Device::Chip::PCF8575 - chip driver for a PCF8575
This Device::Chip subclass provides specific communication to a NXP or Texas Instruments PCF8575 attached to a computer via an I²C adapter.
The reader is presumed to be familiar with the general operation of this chip; the documentation here will not attempt to explain or define chip-specific concepts or features, only the use of this module to access them.
The I²C address of the device. Can be specified in decimal, octal or hex with leading
The following methods documented with a trailing call to
->get return Future instances.
$chip->write( $val )->get
Sets the value of the GPIO pins, as a 16-bit integer.
Pins set low will sink current suitable for signalling or driving an LED. Pins set high will source current via a weak current-source to act as a pull-up for an active-low input signal, such as a button.
$val = $chip->read->get
Reads the current logic levels on the GPIO pins, returned as a 16-bit integer. Pins of interest as inputs should have previously been set to high level using the "write" method.
$adapter = $chip->as_adapter
Returns a new object implementing the Device::Chip::Adapter interface which allows access to the GPIO pins of the chip as if it was a GPIO protocol adapter. The returned instance supports the following methods:
$protocol = $adapter->make_protocol( 'GPIO' ) $protocol->list_gpios $protocol->write_gpios $protocol->read_gpios $protocol->tris_gpios
Paul Evans <firstname.lastname@example.org>